Xado Restoring Grease
XADO Restoring Grease is
designed to restore any mechanism that operates under heavy loads. XADO Restoring Grease forms a new cermet
layer on the friction surfaces: the parts grow in volume and restore
their original geometry. XADO Restoring
Grease considerably extends the life span of the mechanical
The patented formula of this modern restoring
grease is based on a composition of XADO revitalizant and EP complex
Xado Restoring Grease was
used to restore the gears of the Dnepropetrovsky tube-rolling mill
"Ural-2M", which was built over 30 years ago.
Gear problems had been reported and upon
investigation it was found that the main production drive gear had worn
by approximately 30% and the gear surface was covered with scratches
and bubbles 4 mm deep. The wear continued until eventually the unit
needed urgent repair, but the parts were no longer available.
XADO revitalization was the only possible way to
solve the problem. The gear was treated with XADO Restoring Grease and
operated as normal.
After 526 hours of operation the gear was
inspected. It was found that the small scratches and bubbles on the
gear surface had disappeared and the wear had stopped! The
measurements showed that a cermet layer - 400-600 mkm thick (more than
half a millimeter) - had formed on the surfaces of the gears.
The electricity consumption had also reduced by
26,6% at idling and by 12,5% under loads.
Method of application:
Remove the old grease. Fill 1/2 of unit volume with XADO Restoring Grease.
XADO Restoring Grease is especially effective for the restoration and
protection of worn bearings (up to 10,000 rpm). If the bearing assembly
requires a periodical grease change you should use XADO Grease
Protecting later on.
Thickener/Base Oil: Li-soap/Mineral
range °C: -40...+120