Xado Two Stroke Engine Treatment - 2 Stroke Oil additives - Small Engine Dosage - Natures Environmentally Friendly Solution - UK

Xado Small Engine Revitalizant (below 1000cc)

XADO - How much two stroke revitalizant is required?

The amount of XADO two stroke revitalizant required depends on the volume of oil or fuel in your engine, gearbox or fuel tank etc.  Due to the fact that each engine has different issues, each application also requires a different quantity of XADO to achieve lasting results.  In reality it is difficult for us to assess your exact requirements, therefore each application is designed to cover the worst case scenario.

This engine treatment contains 3 x 4.5ml treatments and can be applied to any 2 stroke, 4 stroke or pre mixed fuel and oil systems as well as equipment or engines with separate fuel and oil systems. Each blister pack is applied individually, so you do not have to purchase all three blister packs at the same time.

Once you have completed the full recommended two stroke revitalizant treatment, you will receive a 1 year guarantee, though from experience the application will last significantly longer, which in most cases will exceed the your lifetime ownership of the vehicle.

Note: Remember once you have completed the full treatment our products DO NOT require re application every 20,000 miles, unlike other two stroke products on the market.

Treatment procedure for small engines with combined fuel and oil system

Step 1:

• Squeeze out the content of one sachet into the full fuel tank (it is recommended first to dissolve the content of the sachet in the oil or fuel at temperatures above 20 °C)
• Start the engine and let it idle for no less than 2 min
• Run as normal

Step 2:

• When refilling the fuel tank repeat Step 1.

Step 3:

• Repeat Step 2.

Treatment procedure for small engines with separate fuel and oil system

Step 1:

• Warm up the engine to the operating temperature
• Squeeze out the content of one sachet into the filler of the oil tank
• Start the engine and let it idle for no less than 2 min
• Run as normal

Step 2:

• Repeat Step 1 after 150-250 km (90-150 miles) run of a motorcycle or 4 hours of engine operation (equivalent of 120-150 miles run)

Step 3:

• Repeat Step 1 after 150-250 km (90-150 miles) run of a motorcycle or 4 hours of engine operation (equivalent of 120-150 miles run)

Note!

• The compound is equally effective for any two- and four-cycle engines of any model.
• The treatment is regarded to be completed after no less than 1500 km run or 20 hours of engine operation. It is not necessary to change oil in four-cycle engines before the treatment.
• Double the dose if the volume of the engine is more than 1000 cc.
• XADO revitalizant is compatible with any additives, dopes, metal conditioners, remetallizants etc. regardless of sequence of their application.
• The protective cermet coating forms on the surface made of any alloys. If the surface wear is about 100the worn parts should be replaced.

	Received my Xado small engine treatment quickly for my 2-stroke Peugeot speedfight scooter 100cc. Am very impressed with the increased performance and the reduction in engine noise. I was considering having my bike derestricted (to get 70+mph out of it) but after using the Xado treatment I am hitting this speed without any problem and my bike does not seem to over exert itself when doing this. The adverse weather in my area over the winter 2008/2009 has caused a lot of ignition/cylinder problems for my fellow biker friends but, touch wood, my bike has been fine and I can only presume this is down to the cleansing of cylinders done by the Xado treatment. I will be purchasing more when my current supply runs out. Believe me, buy this and you will see the difference. - Jamie Hopwood